Mechanical travel

360°×n （n:No. of turns）

Protection grade (IP)

IP40

Starting torque

≤5mN·m (50gf·cm)

Stopper strength

Approx. 0.35N·m (3.5kgf·cm)

Appropriate fastening torque of the nut

In the case of panel thickness with over 2.5mm, the rotating torque may become heavier.）

Rotational life expectancy

25℃，No load at 40r.p.m；5 Turns: 2,500,000 shaft revolutions；10 Turns: 5,000,000 shaft revolutions；Total resistance value variation: ≤± 5％ against initial value；Independent Iinearity tolerance: ≤150％ of specified value； Output smoothness：5 Turns: 0.2% against input voltage；10 Turns:0.1% against input voltage

Mass

Bushingmount type：Approx. 25g； Servomount type：Approx. 30g

Operating temperature range

-55℃~+105℃

Temperature cycle

5 cycles under -55℃~+105℃, total resistance value variation: ≤± 5％, No mechanical damage.

Exposure at low temperature

24 hours at -55℃, Total resistance value variation: ≤±5％, No mechanical damage.

Exposure at high temperature

1,000 hours at 105℃, Total resistance value variation: ≤±5％, No mechanical damage.

Vibration

10Hz~2000Hz, 147m/s², 12 hours, Total resistance value variation: ≤±5％, No mechanical and electrical damage.

Shock

490m/s², 11ms, 18 times, Total resistance value variation: ≤±1％, No mechanical and electrical damage.

Moisture resistance

40℃, 95％RH, 120 hours, Total resistance value variation: ≤±10％,Insulation resistance: ≥10MΩ.

Resistance temperature coefficient

±100p.p.m./℃

Standard turns

5 Turns；10 Turns

Standard resistance values

1k,2k, 5k, 10k, 20k, 50k (Ω)；2k, 5k, 10k, 20k, 50k,100k (Ω)

Total resistance tolerance

Standard class ±10%(K)，Precision class ±5%(J)

Independent linearity tolerance

Standard class±0.35%，±0.25%；Precision class±0.2%，±0.1%

Resolution

Essentially infinite

Output smoothness

≤0.05% against input voltage ≤0.015% against input voltage

Contact resistance variation

≤5%C.R.V. ≤3%C.R.V.

Power rating

1.0W 2.0W

Electrical travel

360°×n±5° (n： / Number of turns)

Insulation resistance

≥100MΩ (1000V.D.C.)

Dielectric strength

1000V.A.C./1 min

Special shaft type

Shaft with front and rear extension (Rear shaft with 6mm dia. and 15mm length), Special shaft dia. (φ3mm, φ3.175mm, φ4mm, φ5mm) , special machining on the shaft

Speical turns

3Turns（S22HHPM-3）

With high torque

With high torque

Extra tap

Extra taps (Available up to 1 tap only for 10-turn model)

Slipping-clutch incorporated type

Slipping-clutch incorporated type (20mN•m~60mN•m)

Multi-ganged

Up to 10 gangs

Speical protection grade (IP)

IP54 Simple sealed housing